K2 PLASTIC DOCTOR WHITE 28G

Professional system plastic welding

Product index: B102
Barcode: 5906534014665
  • Description

    A fast setting two part epoxy designed for permanent bonding of various plastic materials, different metal parts, ceramic, porcelain, fiberglass, glass, PVC, leather, wood and many other surfaces. Resistant to water. Perfectly fills the gaps. The mixed product will remain workable for only 3-5 minutes. Sets initially in 10 minutes and bonds within 2 hours. The maximum bond strength is achieved after 24 hours. Fully cured with a temperature range of -40°C to 121°C. NOTE: Low temperatures lengthen set time. Not recommended for polyethylene and polypropylene plastics.

    Directions: Bonding surfaces should be clean, dry and roughen for better adhesion. Remove storage cap located in plunger. POINT TIPS AWAY FROM FACE WHILE OPENING. Point syringe towards the mixing tray and snap off the tip end or cut it off using a knife. Use either plastic blister or clean cardboard to mix the components. DO NOT MIX on metal surfaces. Press down slowly on plunger to dispense equal parts of resin and activator. Always use a clean NON-METAL device to mix thoroughly until the colour becomes uniform. Apply the mixed product to both surfaces to be bonded and press together with a clamp, tape or weight. Immediately remove epoxy excess with a damp cloth. Use acetone based remover to eliminate epoxy excess before hardening. For syringe seal, pull back on plunger, wipe tips and firmly place cap on them (see illustrations below). NOTE: Always place storage cap in the same way to avoid mixing of components. Store upright with tips up.

    WARNING! Prolonged exposure to temperatures above 29°C may result in pressure build-up within closed syringe. Use caution when opening, always point tips away from face and body. Avoid contact with drinking water. For colour pre-check mix small amount on clean cardboard and view the result after 48 hours.

  • Presentation